Making a Vaporizer is no Longer a Pipe Dream

Day by day, the popularity of a vaporizer is increasing owing to its amazing benefits as to health. It is a wonderful alternative to smoking with no harmful side-effect at all. They are generally used to inhale, medicinal marijuana, tobacco and aromatherapy treatments. It is preferred as an alternative to direct smoking in other parts of the world as well such as the Middle East and Turkey.

Making a vaporizer is not a pipe dream. With a few things, one can easily make a vivacious vaporizer. There is a list of a few things that are required to have in order to make a vaporizer at home.

1. Bottle with metal or plastic cap
2. Soldering iron
3. Gloves
4. Razor-sharp knife
5. Plastic or turbing straws (an empty plastic pen also works)
6. Light bulb
7. Tape (electrical or duct tape)

These are the building blocks of the home made vaporizer.

With all the above mentioned things, one is in business. There are a few steps that have to be followed to make a nice vaporizer. These are as follows;

Step1

Firstly the end of the light bulb should be cut at the last turn of the metal screw.

Step2

Then, the wiring should be removed within the light bulb. While doing so it should be made sure that no fragments of glass are left.

Step3

In the third step, two well rounded holes on a metal or plastic cap bottle should be made; afterwards the cap should be put on the light bulb. Tape should be used to secure it and build a container which is airtight.

Step4

Fourthly, a straw is inserted into one of the two holes and the other hole is left clear. It will work as a smoker which allows any excess or extra vapor to get dissolved.

Step5

The penultimate and most important step is an act of placing the intended herb to be smoked through the hole.

Step6

In the final step heat should be generated underneath the light bulb using a lighter. Soon after the generation of heat herbs will begin to release vapors.

Last but not the least, when a vaporizer is made, it should be kept in mind that it will not last for a longer period of time. It is generally short-lived. The glass eventually cracks because of the constant heating and cooling. So whenever it goes out of work, one should always build a new vaporizer.